![]() The only difference is that you need to provide a positive gate to source voltage to turn it off. The operating principle is also similar to an N-channel JFET. The source and drain terminals are taken from the other two sides of the channel. Like in an N-channel JFET, the gate terminal is formed by joining the N-type regions at both sides. The opposite side of the channel is heavily doped with N-type substrates. Therefore the flow of current through the channel is positive in the form of Holes. Similarly, in the P-channel JFET, the channel is doped with acceptor impurities, making it a P-type semiconductor. A depletion region is created in the channel that makes the channel narrower, increasing the channel resistance between the source and drain, and the current flow becomes less. The amount of current flow is determined by the potential difference between source and drain terminals and the internal resistance of the channel.īut the reverse thing happens when a negative voltage is applied to the gate terminal with respect to the source terminal, making the P-N junction reverse biased. Therefore maximum current flows from the source to the drain terminal. When no voltage is applied across the gate terminal, the channel becomes a wide-open path for electrons to flow. The gate (G) lead is connected internally to both the P-type terminals, while the drain (D) and source (S) leads are connected to either end of the N-type channel. ![]() Thus two PN junctions are formed by those heavily doped P-type regions and the N-type channel in between. Two P-type substrates doped at the opposite sides of its middle part. Therefore the flow of current through the channel is negative in the form of Electrons. In the N-channel JFET, the channel is doped with donor impurities, making it an N-type semiconductor. The JFET transistors are available in both N-channel and P-channel types. That is why JFETs are referred to as “normally on” devices. By applying a reverse bias voltage to the gate terminal, the channel is strained, so the electric current is switched off completely. The voltage applied between gate and source controls the flow of electric current between the source and drain of the JFET. The current flows through an active channel between sources to drain terminals. The Junction Field Effect transistor (JFET) is the earliest type of FET. FET ClassificationįET transistors are classified into Junction Field Effect transistors (JFET) and Metal-Oxide-Semiconductor Field-Effect Transistor (MOSFET) transistors. Careful connections and design are critical to maintaining FET performance when the Body connection is involved.Ĭhannel: This is the region in which the majority carriers pass from the source terminal to the drain terminal. However, in integrated circuits, this pin will be typically connected to the most negative power supply in an NMOS circuit(most positive in a PMOS circuit) because many transistors will share it. In discrete applications, it is internally tied to the source pin allowing its effects to be ignored entirely.
0 Comments
Leave a Reply. |